Frame anchor – BD – FRAMER

Due to its long shaft, the KTS blind frame anchor is the optimal anchor for push-through installation. Due to its length, it bridges any attachments and non-load-bearing layers. The additional rotation locks on the dowel shaft prevent rotation even under unfavorable conditions.

USE: concrete, perforated brick, hollow block, sand-lime perforated brick, aerated concrete, lightweight concrete, solid pumice block, etc.

This information should be considered as a general recommendation. This information should be regarded as general recommendations. More specifically, please note that these plugs and anchors may not be used for work subject to building inspections (e.g. for securing façade substructures, roofs etc.).

* Safety factor 3

Technical data BD – Frame anchor
Small packaging10 x 80 mm10 x 100 mm10 x 120 mm10 x 140 mm10 x 160 mm
Article-No.pozi 417610080411761010041176101204117610140411761016041
Countersunk wood screw mm7 x 857 x 1057 x 1257 x 1457 x 165
Packaging unitPiece50 / 25050 / 25050 / 25050 / 25050 / 250
Weight per packing unitpozi 45.7 kg.7.6 kg.8.6 kg.10.8 kg.12.7 kg.
Weight per packing unitTORX5.7 kg.7.6 kg.8.6 kg.10.8 kg.12.7 kg.


Factory test BD – Frame anchor
Material: NYLON (polyamide 6)
Diameter mm1010101010
Length mm80100120140160
Drill hole Ø mm1010101010
Minimum hole depth mm90110130150170
Minimum installation depth mm80100120140160
Maximum useful length mm30506585110
Concrete pull-out value (kN)*2,002,002,002,002,00